Updating boot path


Install the setup file and start it or just start the portable.If you have a limited user account on the host OS you need to start it as an administrator, because only this way it will properly check and use the real (USB) drive.The Recovery Mode still uses a conventional U-Boot.On Apalis the recovery U-Boot is built for the IT modules RAM requirements which works well on both IT and non IT versions.But when trying to update the firmware for a few phones there is a new process which was introduced with the 4.0 release of UCS.

updating boot path-76updating boot path-37updating boot path-70

You need to configure "Internet Settings" of Quick Update to get Internet access.In case the above problem remains as it is even after following the above step then we will recommend you to contact Quick Heal Technical Support Team.In the mean time you can also update your copy of Quick Heal manually by downloading exe file from Web page.Also the firmware was packaged differently in the previous SIP versions as the device firmware was provided as two separate binary files, the bootloader image and the application image.In the 4.x UCS release these were merged into the same binary file.We provide Open Embedded recipes which build U-Boot and Linux as part of a complete image, hence if you plan to build a complete image follow the Open Embedded (core) article.

You must have an account to comment. Please register or login here!